Pioneer PDK-WM01 Manual De Instrucciones página 12

Installation Procedure
When removing the plasma display
Before beginning this procedure, turn off the power
to the plasma display and peripheral devices and re-
move their power plugs from the outlets. As neces-
Caution
sary, also remove connecting cables.
1
Loosening the screw on the tilt adjust-
ment metal fitting.
Note
Removing the plasma display without removing the tilt ad-
justment metal fitting may scratch the wall.
2
Removing the push rivet and the anchor
screws that are holding the lock plate, and
the anchor screws that are holding the
PDP metal fitting (2 locations: left and
right sides).
Anchor screw
Lock plate
3
Unlocking the lock bar (2 locations: left
and right sides).
12
En
Push rivet
Anchor screw
Lock
bar
Locked
Unlocked
position
position
Set the lock bar in its unlocked
position
4
Raising the lock bar and pulling the bot-
tom of the plasma display forward.
Pull out the bottom of
the plasma display.
Pull out the bottom of the plasma display very
carefully so that the hook on the PDP side
metal fitting is not displaced.
Caution
5
Raising and removing the plasma display.
Raise and remove the plasma display.
Always have at least 2 people do this task.
Caution
Raise the
lock bar
(either the
left or the
right side).