Checking The Parts; Service Parts List; Installation Procedure - Pioneer PDK-WM01 Manual De Instrucciones

Checking the Parts

Check the parts before beginning assembly.
Note
Screws used to fix the wall-hanging metal fitting firmly to
the wall surface are not included. Purchase these separately.
Philips driver separately.
Hung on wall unit x1
Tilt adjustment metal fitting x1
Hexagon wrench x 1
(Opposite side 6 mm for M8 use)
Operating instructions
(this document) x 1
壁掛け型プラズマディスプレイ金具
HUNG ON WALL UNIT
ECRAN MURAL
WANDBEFESTIGUNGSEINHEIT
UNITA' DA PARETE
EENHEID VOOR WANDBEVESTIGING
UNIDAD PARA COLGAR DE LA PARED
PDK-WM01
「据付工事」について
本機は十分な技術・技能を有する専門業者が据え付けを
行うことを前提に販売されているものです。 据え付け ・ 取
り付けは必ず工事専門業者または販売店にご依頼くださ
い。
なお、据え付け、取り付けの不備、誤使用、改造、天災な
どによる事故損傷については、弊社は一切責任を負いま
せん。
取扱説明書
Operating instructions
Mode d'emploi
Bedienungsanleitung
Istruzioni per l'uso
Gebruiksaanwijzing
Manual de instrucciones

Service Parts List

Mark No. Description
BOLT M8
SCREW M6
PACKING SET
OPERATING INSTRUCTIONS AZR1074-
TILT ADJUSTMENT
METAL FITTING
1
Bolts M8 x 6
Stencil x 1
2
Parts No.
AZB1435-
AZB1438-
AZH1158-
AZR2560-

Installation Procedure

Removing the push rivet of the lock plate
and the bottom anchor screw (M6 x 14mm)
(2 locations: left and right sides).
1 Move the push rivet of the lock plate to its unlocked
position so the lock plate is in the condition shown in
the figure.
2 Remove the anchor screw from the bottom.
Lock plate
Anchor screw (M6 x 14mm)
Note
Be careful not to lose the 2 anchor screws (M6 x 14mm)
because they will be used later.
Releasing the lock bar (2 locations: left and
right sides).
Lock bar
Pull the
push
rivet
Locked Unlocked
position
position
Push rivet
Lock
bar
Locked
Unlocked
position
position
Set the lock bar in the
unlocked position.
9
En