Troubleshooting; Engine Will Not Start - Flotec HYDROBLASTER 1.8 Manual Del Usuario

8． TROUBLESHOOTING
ENGINE WILL NOT
START
12 Electric starting:
check battery
2. Check
positions
3. Check fuel.
4. Remove
inspect
plugs.
5. Take engine to an
authorized
servicing dealer,
or refer
manual.
ENGINE
POWER
1. Check air filter
2. Check fuel.
3. Take engine to an
authorized
servicing dealer,
or refer
manual.
Possible Cause
Battery discharged.
Fuel valve OFF.
control
Choke OPEN.
Engine switch OFF.
Out of fuel.
Bad fuel; engine stored
without treating or draining
gasoline, or refueled with
bad gasoline.
Spark plugs faulty, fouled,
or improperly gapped.
and
spark
Spark plugs wet with fuel
(flooded engine).
Fuel filter
carburetor
ignition malfunction, valve
to
stuck, etc.
LACKS Possible Cause
Filter element(s) clogged.
Out of fuel.
Bad fuel; engine stored
without treating or draining
gasoline, or refueled with
bad gasoline.
Fuel filter
carburetor
ignition malfunction, valve
to
stuck, etc.
Recharge battery.
Move lever to ON.
Move lever to CLOSE
unless engine is warm.
Turn engine switch to
ON.
Refuel
Drain
carburetor. Refuel with
fresh gasoline.
Gap, or replace spark
plugs.
Dry and reinstall spark
plugs. Start engine with
throttle lever in FAST
position.
clogged,
Replace or repair faulty
malfunction,
components
necessary.
Correction
Clean or replace filter
element(s).
Refuel
Drain
carburetor. Refuel with
fresh gasoline.
clogged,
Replace or repair faulty
malfunction,
components
necessary.
28
Correction
fuel tank and
as
fuel tank and
as