Functional Description - Milwaukee 2313-059 Manual De Instrucciones

symbology
Volts
Direct current
To prevent electric shock, do
not allow product to contact
live electrical parts
Seal of Electrical Security
Read operator's manual
Wear eye protection
AssEmbly
wARNINg
charger specified for the battery. For specific
charging instructions, read the operator's
manual supplied with your charger and
battery.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Attaching/Removing Accessories
To attach an accessory, hook the two front hooks
over the front of the camera. Press the clip over the
back end of the camera to snap it into the detents.
To remove, pull up on the clip and then unhook
the accessory.
Hooks
Recharge only with the
Clip

fuNCTIoNAl DEsCRIPTIoN

5
6
7
Cat. No.
2313-059
2314-059
wARNINg
wear safety goggles or glasses with side
shields. Always remove battery pack before
changing accessories or making adjustments.
Turning On/Off
Press the Power
and hold the Power
Sleep Mode
The tool will shut off automatically if unused for 5
minutes. To reset, press the Power button again.
Fuel Gauge
To determine the amount of charge left in the bat-
tery, turn on the tool. The Fuel Gauge will light up
for 2-3 seconds.
To signal the end of charge, 1 light on the fuel gauge
will flash for 2-3 seconds.
Camera LED
The camera LEDs can be adjusted to 4 levels
of brightness and turned off. Press the camera
Detent
LED brightness increase and decrease buttons to
change the level of brightness or turn it off.
10
3
4
1. Camera
2. Camera LEDs
3. Cable
4. Rotating LCD
5. Fuel gauge
6. Power button
7. LED brightness
increase/decrease
buttons
sPECIfICATIoNs
Volts DC
12
12
oPERATIoN
To reduce the risk of injury,
button to turn the tool on. Press
button to turn the tool off.
1
2
Cable Length
0.9 m (3')
2.75 m (9')