Brake Handle Assembly - Medline MDS86835DSHEC Instrucciones De Usuario

Brake Handle Assembly

1. Insert hand grip into appropriate hole (see Figure A and chart below).
Note: Keep brake cable on outside of walker.
2. Insert triangular hand screw into hole on outside of walker frame
(see Figure B).
DO NOT put hand screw in open slot at end of hand grip!)
3. Hand tighten screw until secure (see Figure C).
(Important: Hand Tighten Only!)
4. Repeat steps 1-4 for other hand grip.
Figure A
(Important: Insert hand screw into one of the 4 holes provided.
Figure B
Seat height adjustable from 18-23" (46-58 cm)
Handle height adjustable from 29-36" (74-91 cm)
To determine proper height, stand upright behind the walker with
shoulders relaxed, arms hanging at your side and eyes looking straight
ahead. Standing in current position, the hand grips (A) of the walker
should be adjusted to a height even with the wrists. This will position
the arms at an approximated 20 to 30 degree bend when using the
walker. Secure the wheels to the closest hole to the desired height.
Insert and tighten the triangular hand screws until secure.
(Important: Hand Tighten Only!)
Figure C
1-800-MEDLINE (633-5463) | medline.com 9