Dometic CA1000 Instrucciones De Montaje página 28

_IA_CA1000.book Seite 28 Donnerstag, 12. Juni 2008 11:53 11
Installation
7.2.2 Installation in an existing sunroof opening
I
Note
Existing roof hatch openings of 400 to 435 mm are suitable for the instal-
lation of the roof air conditioner.
I
Note
The manufacturer only assumes liability for parts included in the scope of
delivery. The validity of the warranty expires if the device is installed to-
gether with third-party parts.
a
Caution – risk of damage
Please observe the structural engineering of the vehicle and seal of all
openings made when installing the roof air conditioner.
Removing the roof hatch
➤ Remove all screws and fixtures of the existing roof hatch.
➤ Take out the roof hatch.
➤ Remove the sealant around the opening using a scraper or similar tool
➤ Use a sealant to seal the bore holes (fig. 6, page 3).
I
Note
Dispose of all waste material, glue, silicone and seals separately. Ob-
serve the disposal guidelines.
Laying the power cable (fig. 7, page 4)
7.2.3
e
Caution – danger of electrocution
Make sure there is no voltage at electrically operated components before
carrying out work on them!
➤ The roof air conditioner must be connected to an electric circuit which
7.2.4 Pre-assembly of the roof air conditioner
➤ Screw the M8x160 threaded bolts supplied into the openings provided
I
Note
The threaded bolts supplied can be used for roof thicknesses of
35-50 mm. For roof thicknesses of less than 35 mm, the threaded bolts
must be shortened accordingly.
Example of shortening the bolts:
35 mm (minimum roof thickness) – 25 mm (measured thickness)
= The threaded bolts must be shortened by 10 mm.
28
(fig. 5, page 3).
is able to supply the required current.
on the underside of the system (approx. 18 mm deep).
Dometic CA1000