Menu Level 3: Operating Mode - Dometic CA1000 Instrucciones De Montaje

Ocultar thumbs Ver también para CA1000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
_IA_CA1000.book Seite 32 Donnerstag, 12. Juni 2008 11:53 11
Installation
7.3.3
Menu level 2: Switching from AC to AC/DC operation
You can upgrade the roof air conditioner with the CA-DC kit so that it can
not only be used with the vehicle stationary, but also while driving. To do
this, you must reconfigure the system software. No alterations need to be
made in this menu when you operate the system without a CA-DC up-
grade kit.
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (fig. e 5, page 6) shows the menu level
➤ Press the + button (fig. e 6, page 6) once to switch to menu level 2.
➤ Press the Mode button (fig. e 4, page 6) to change the parameter.
✓ The digits in the display flash until the parameter you enter is con-
➤ Press the + and – buttons (fig. e 6 und 7, page 6) to select AC mode
➤ Press the Mode button (fig. e 4, page 6) to confirm your entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 2 and can use the + and – buttons to switch
7.3.4

Menu level 3: Operating mode

The system always starts with a defined operating mode for room temper-
ature. This parameter can be configured:
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (fig. e 5, page 6) shows the menu level
➤ Press the + button (fig. e 6, page 6) twice to switch to menu level 3.
➤ Press the Mode button (fig. e 4, page 6) to change the parameter.
✓ The digits in the display flash until the parameter you enter is con-
➤ Use the + and – buttons (fig. e 6 and 7, page 6) to select the mode
➤ Press the Mode button (fig. e 4, page 6) to confirm your entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 3 and can use the + and – buttons to switch
32
mode" on page 31).
and the second and third show the parameter which can be set.
firmed.
01
(
) or AC/DC mode (
between menu levels.
mode" on page 31).
and the second and third show the parameter which can be set.
firmed.
the system starts in (e.g.
between menu levels.
02
).
00
for automatic mode or
Dometic CA1000
01
for mode 1 etc.).

Publicidad

Tabla de contenido
loading

Tabla de contenido