Use Of The Appliance; Operation Of The Breadmaker - essentiel b EMP1104 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

use of the appliance

Operation of the breadmaker

1.
Grease the bread pan with heat-resistant margarine or butter to prevent the dough from sticking to
it.
2.
Grease the kneader with heat-resistant margarine or butter. This will prevent the dough from
sticking to the kneader and facilitate its removal after use.
3.
Slide the kneader over the drive shaft in the bread pan. Make sure it is fully pushed down.
4.
Fill your ingredients into the bread pan (
!
Warning! Do not overfill the bread pan! Fill a maximum of 500g of flour and 11g of yeast into
it to avoid overflowing and subsequent damage of the appliance.
5.
Place the appliance on an even, stable and heat-resistant surface able to hold its weight.
6.
Insert the bread pan into the appliance by turning it clockwise to lock it (
down the handle of the bread pan. Close the lid.
7.
Connect the power plug to a suitable electrical outlet. An acoustic signal sounds and the display
shows "2:50". The appliance is now in default mode "1 Basic" and set to medium colour and
Large weight (750g).
8.
Press the mode selection button
9.
Adjust the colour of the crust and weight of the bread/cake with the weight
adjustment buttons (if adjustable for selected mode). Three colours of crust can be selected Light,
Medium, Dark. Two weights of bread can be selected: Small (500g) or Large (750g).
10.
To delay the start of the appliance, set the timer with the timer
for selected mode). A delay time is added to the baking time in 10-minute steps. The bread will be
finished when the time shown on the display has elapsed. The maximum delay time is 13 hours.
Do not use the timer when your dough contains easily spoiling fresh ingredients such as
eggs, milk, cream or cheese.
11.
Press the
down the set delay time and then starts the operation. The symbol ":" flashes on the display.
To cancel the current program, hold the button
acoustic signal sounds and the screen displays the initial time of the selected program.
12.
When operation is finished, an acoustic signal sounds.
Optional: If the colour of the bread/cake is too light, baking time can now be added by choosing
mode "12 Bake" and adjusting the time with the timer
button to start the operation. When operation is finished, an acoustic signal sounds.
43
V.1.0
use of the appliance
button to start the operation. If the timer is activated, the appliance starts to count
Practical advice / recipes).
repeatedly to select the desired mode (
LOCK). If necessary, pull
Mode description).
and colour
and -
buttons (if available
pressed for approx. 2 seconds. An
and
buttons. Press the

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido