Maintenance Instructions; Sharpening Of Blades - TRAPP ES-500 Manual De Instrucciones

Belts
It is recommended to weekly check usage
conditions and stretching of all transmission belts
of the animal ration shredder (motordriven or with
tractor accessories).
Attention!
All maintenance and cleaning shall be
done with the equipment off.
How to tension the belt(s) that activate
the feeder cylinders
In order to change the pulley cavity and change the
material cutting size, you must move the machine
transmission box,
according to Figure 12:
Remove the 2 screws (A) and the protection (B).

Loosen the 4 screws (C) that secure the transmission

box (E).
Turn the screw (D) in order to increase or decrease

tension on the belts, as required.
Then reassemble all the unassembled items and

tighten them as required.
Image merely
illustrative
C
D
Figure 12
54

Maintenance Instructions

following the directions
E B
Lubrication
Gearbox (A)
Figure 13
When performing any maintenance, do not allow

any foreign material to enter into the transmission
box (1).
To drain the oil it is necessary to remove the drain

plug located on the bottom of the gearbox.
Whenever performing an oil change, use 800 ml of

SAE-140 oil.
After placing the oil check the level through the oil

sight glass (2). Since it must be immersed in oil. Use
the oil sight glass to check the oil level regularly.
Change oil after the first 50 hours of use.

The following oil changes shall be made every 300

hours of use.
Periodically check the oil level, and fill up if

necessary.

Sharpening of blades

To keep cutting quality and to obtain the best
performance of your animal ration shredder, keep
blades in good working conditions. Periodically
check the status of the blades, sharpening them
A whenever necessary.
To sharpen or change blades, follow the directions
according to Figure 14:
Open the cover (A).

Disassemble all rotor blades (B), removing securing

screws (C).
www.trapp.com.br
1
2