Beper 40.961 Manual De Instrucciones página 9

EN
6 in 1 hair and beard trimmer set Use Instructions
Charging the appliance:
Plug the battery charger into an electrical outlet.
When the appliance is off, connect the battery charger to the the appliance.
The total charging time is 8 hours. When the appliance will be fully charged, it can be used continuously for 45
minutes. The working light (red) will light up during charging. NOTE: the red working light will be switched on
when the appliance is charging as well as when using.
Never keep the adapter plugged into the electrical outlet all the time. Connect it only when it will be necessary.
Switch on the appliance only after charging the battery.
Use:
1. Apply the accessory you want to use to the appliance
2. To remove the accessory, hold the hair trimmer with both hands and press the blades out with your thumb and
support the blades with the indicator to avoid falling.
3. Switch on the appliance
4. Hold the appliance in your palm creating a perpendicular angle (90°).
5. During the use always keep the appliance in touch with your skin, without applying too much pressure.
7. Put the the appliance closer to the area to be trimmed and gently move the appliance from bottom to up side .
8. If you want to cut the hair in the nose and ears, select the accessory of cutting, when the appliance is switched
off. After applying the accessory switch on the appliance.
Note: During use it is normal that the metal part of the blade will have a gentle heating.
Use of accessories:
The hair trimmer is equipped with 4 combs with different heights between 3mm, 6mm, 9mm and 12mm.
The accessory for cutting body hair can be used with or without the comb, depends on the length of the hairs to
be trimmed.
The precision trimmer's blade is used to create more details on your beard and/or mustache.
Cleaning and maintenance:
Before cleaning the appliance turn it off, remove the accessory and the blade used and clean with the cleaning
brush equipped with the product.
Clean the appliance with a damp cloth and then dry it.
After cleaning the blades put a drop of oil and switch on the appliance without use it, for aprox. 10 seconds.
Clean the appliance after each use.
DURING CLEANING OPERATIONS BE CAREFUL THAT THE BLADES ARE SHARPENED AND YOU CAN
ENJURE.
ATTENTION:
Never immerse the appliance and the adapter in water.
• Never clean the appliance with liquids, creams and corrosive products.
When you don't use appliance store it and its accessories on his base than place it in a dry place and out of the
reach of the children.
Don't clean the appliance under the tap but using the appropriate brush.
TECHNICAL DATA:
ADAPTOR
INPUT: 100-240V-50/60Hz
OUTPUT: 4.5V - 1000 mAh
Ni-Mh Battery: 700 mAh
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9