Troubleshooting Schedule; Troubleshooting - Jonsered FR 2312 MA Manual De Usuario

2. To make it easier to drain the oil without spill, attach
for example a plastic hose to the end of the oil drain
plug.
3. Put a container below the oil drain plug.
4. Remove the dipstick.
5. Turn the oil drain plug counterclockwise and pull out
to open it.

Troubleshooting schedule

If you cannot find a solution to your problems in this
owner's manual, speak to your Jonsered service agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
24

Troubleshooting

Cause
The parking brake is not applied. See
page 16 .
The lift lever for the cutting deck is in mow position. See
ting deck on page 13 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
battery on page 21 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
6. Let the oil run out into the container.
7. Push the oil drain plug in and turn it clockwise to
close it.
8. Remove the plastic hose and put the cap on the oil
drain plug back.
9. Fill with new oil as given in
27 .
10. Start the engine and let it idle for 3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Fill with oil to compensate for the oil held in the new
oil filter.
Note: For safe disposal of used engine oil, see
on page 26 .
To apply and release the parking brake on
To replace the main fuse on page 21 .
To charge the battery on page 21 .
To fill fuel on page 12 .
Technical data on page
Disposal
To lift and lower the cut-
To charge the
828 - 001 -