Problem
The engine does not run smooth-
ly
The engine apparently has no
power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry
Transportation
•
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
•
Use an approved trailer for transportation of the
product.
828 - 001 -
Cause
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
charge the battery on page 21 .
The blades are loose. See
One or more of the blades are unbalanced. See
22 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
18 .
The tire pressure is different on the right and left sides. See
page 22 .
The product is operated at a too high speed. See
16 .
The engine speed is too low. See
The drive belt slips.
Transportation, storage and disposal
To replace the air filter on page 19 .
To replace the air filter on page 19 .
Battery safety on page 10 .
To examine the blades on page 22 .
To examine the blades on page
To examine the blades on page 22 .
To get a good result on page 16 .
To get a good result on page 16 .
•
Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To clean the product on page
Tire pressure on
To get a good result on page
To
25