Skil PWRCORE 12 RI574501 Manual Del Propietário página 13

Halo Light
Your tool is equipped with Halo light, located
on the head of the tool. This provides additional
light without shadows on the surface of the
work-piece for operation in lower-light areas.
The Halo light will automatically turn on with
a slight squeeze on the variable-speed trigger
switch before the tool starts running and will
turn off 8 to 12 seconds after the variable-
speed trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off, and the halo light will rapidly
flash. Rest the tool for a while or place the tool
and battery pack separately under air flow for
cooling.
The Halo light will flash more slowly to indicate that the battery is at low-battery capacity,
Recharge the battery pack.
Removable Belt Clip (Fig. 6)
Your tool is equipped with removable belt clip,
which can be positioned on the left side of the
tool for convenient transport.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib of the belt clip with the threaded
hole on the base of the tool.
c. Insert the screw and securely tighten the
screw with a screwdriver.
Remove the belt clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver to loosen the screw that
attaches the belt clip to the tool.
c. Remove the screw and the belt clip.
Fig. 5
Halo Light
Fig. 6
Belt clip
13