Working Instructions - Bosch DLE 150 Connect Professional Instrucciones De Servicio

4.
5. Select and mark the desired unit on the basis of its serial number. By
clicking on the "OK" button, the selection is acknowledged.
To perform a new search for available units, click on the "New Search"
button.
6.
The selection steps 4. and 5. are skipped when, at the start of the soft-
ware on the PC or the PDA, the DLE 150 Connect to which a wireless
connection last existed is within range.
Quitting the "BOSCH DLE 150" Software

Working Instructions

The instrument measures from the back end of the case.
– The receiving lens and the outlet of the laser beam should not be cov-
ered during a measurement.
– For the wireless connection, it is not necessary that a line of sight ex-
ists between the DLE 150 Connect and the PC or PDA. However,
transmission barriers (e.g. steel-reinforced concrete walls) reduce the
range.
1 609 929 F53 • (04.07) T
The DLE 150 Connects found are dis-
played by the software. The last six dig-
its of the serial number serve to distin-
guish between the individual units. The
serial number 21 can be found on the
nameplate on the underside of the unit.
If a DLE 150 Connect was selected and
the selection acknowledged, a connec-
tion will be established to that unit ("Con-
nect the DLE 150 Connect" indication).
The display shown here then appears
with the serial number of the connected
DLE 150 Connect. The PC or PDA is
now ready to receive measured values.
To quit the software, select the "End" menu
item in the "File" menu on the menu bar.
This also interrupts the wireless connection.
English–7