Safety Instructions; General Safety Instructions; Machine-Related Safety Instructions - Festool T 12+3 Manual De Instrucciones

GB
T 12+3, T 15+3, T 18+3
* Speed specifications with fully charged battery pack.
** The maximum speed is reduced in the lower torque stages.
Charger
Mains voltage (input)
Mains frequency
Charging voltage (output)
Rapid charging
Conservation charging current, pulsating (only NiCd, NiHM)
Charging times for
Permitted charging temperature range
Temperature monitoring
Battery Pack
Voltage
Capacity
Weight
5

Safety instructions

5.1

General safety instructions

WARNING! Read all safety warn-
ings and all instructions. Failure to
follow the warnings and instructions may re-
sult in electric shock, fire and/or serious in-
jury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool
or battery-operated (cordless) power tool.
5.2 Machine-related safety instruc-
tions
– Hold power tool by insulated gripping
surfaces, when performing an opera-
tion where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the
power tool "live" and could give the opera-
tor an electric shock.
– The charger and power tool are not in-
tended for use by persons (including
children) with limited physical, senso-
ry or mental ability or without suffi-
cient experience and/or knowledge,
unless they are supervised by a per-
son responsible for their safety or
have been instructed on how the
charger or power
used.Children should always be super-
14
LiIon 1.5 Ah/ 3.0 Ah, 80 %
LiIon 1.5 Ah/ 3.0 Ah, 100 %
BPC 12 Li
tool is to be
BPC 15 Li
10,8 V 14,4 V
3,0 Ah 3,0 Ah
0,49 kg 0,58 kg
vised to ensure that they do not play with
the charger or the power tools.
– Switch of the power tool immediately
if the tool is blocked. Always be pre-
pared for high reaction torques that
can cause kickback.
The tool blocks if:
- the power tool is overloaded or - it be-
comes jammed in the workpiece being pro-
cessed.
– Wait until the power tool stops com-
pletely until placing it down. The tool
can become entangled and lead to a loss of
control of the power tool.
– Avoid unintentional activation. Ensure
that the on/off switch is in switched-
off position before inserting a battery.
Carrying the power tool with your finger at
the on/off switch, or inserting the battery
when the power tool is switched on, can re-
sult in accidents.
– Take care when drilling into walls as there
is a danger of rupturing concealed gas/wa-
ter pipes or cutting through power cables.
– Do not open the battery pack or the charg-
er. Even after disconnection from the
mains, there is still a high capacitor voltage
inside the charger.
– Make sure that metal objects (such as met-
al chips) or fluids do not collect in the bat-
tery pack retaining slots or enter the
TRC 3
220 - 240 V ~
50/60 Hz
7.2 - 18 V=
max. 3 A
approx. 0.06 A
approx. 25/ 55 min
approx. 35/ 70 min
-5 °C to +45 °C
via NTC resistor
BPC 18 Li
18 V
3,0 Ah
0,68 kg