External Remote Input; 12V Trigger Connection; Troubleshooting; Fuse Replacement - Rotel RCD-06 SE Manual De Instrucciones

English
External Remote Input
This 3.5 mm mini-jack (labeled EXT REM IN) receives command codes
from an industry-standard infrared receiver (Xantech, etc.) located in the
main listening room. This feature is useful when the unit is installed in a
cabine and the front-panel sensor is blocked. Consul your authorized
Rotel dealer for information on external receivers and the proper wiring
o a jack to fit the mini-jack receptacle.

12V Trigger Connection

The RCD-06 SE can be activated by a 12 volt trigger signal from a Rotel
preamplifier. The trigger input accepts any control signal (AC or DC)
ranging from 3 volts to 30 volts. When a cable is connected to the input
and a trigger signal is present, the CD Player is activated.
When the trigger signal is interrupted, the unit goes into standby mode.
The front panel indicator light remains lit , but the display goes dark and
the unit will not operate.
Note:
When using the 12V Trigger feature, leave the POWER button
in the ON position.

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the fault
and make the necessary changes. If you are unable to get sound from the
RCD-06 SE, refer to the suggestions for the following conditions:
Power Indicator Is Not Lit
The Power Indicator and the basic items in the Display window should be
lit whenever the RCD-06 SE is plugged into the wall power outlet and the
Power button is pushed in. If it does not light, test the power outlet with
another electrical device,such as a lamp. Be sure the power outlet being
used is not controlled by a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged into the power outlet,
but the Power Indicator and the Display still will not light when the
RCD-06 SE is plugged into the wall outlet, it indicates that the internal
power fuse may have blown. If you believe this has happened, contact
your authorized Rotel dealer to get the fuse replaced.

NO SOUND

Check the cables between the RCD-06 SE and the amplifier inputs to be
sure they are connected properly. Be sure the correct amplifier input is
selected. Be sure the tape monitor system of the amplifier has not been
activated. Check the wiring between the amplifer and the speakers.
w
q

Specifications

Total Harmonic Distortion + Noise
Intermodulation Distortion
Frequency Response (±0.5db)
Channel Balance
Phase Linearity
Channel Separation
Signal to Noise Ratio
Dynamic Range
Digital to Analog Converters
Speed Accuracy, Wow & Flutter
Output Impedance
Digital Output
Load Impedance
Power Requirements
Power Consumption
Dimensions (W, H, D)
Panel Height
Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of
The Rotel Co, Ltd., Tokyo, Japan.
9
0.0045%@1kHz
0.0045%@1kHz
20-20,000 Hz
±0.5db
±0.5degree
> 98 dB @ 1kHz
> 100dB
> 96 dB
Wolfson
Quartz Crystal Precision
100 Ohms
0.5 Volt, Peak to Peak
75 Ohms
AC 230V, 50 Hz
20 Watts
17 1 / " x 2 7 / " x 12 5 / "
8 8 16
437 x 73 x 313 mm
"
60 mm / 2 3 /
8
5 kg, 11lbs