Clearing Foil Jams; Cleaning And Servicing - Olympia A 296 Plus Manual De Instrucciones

Clearing Foil Jams

The laminator is provided with the "Jam Release" function in order to clear
foil jams quickly.
If the foil pocket jams, switch the laminator off and actuate the "ABS"
1
switch on the rear of the unit.
2 Hold the laminator firmly and pull the foil pocket together with the doc-
ument to be laminated out of the laminator's insertion slot.
3 It will probably be necessary to then clean the device several times as
described in the Section "Cleaning and Servicing".
If foil pockets jam repeatedly or jammed foil cannot be removed from
4
the laminator, please contact the sales outlet where you purchased
the device.

Cleaning and Servicing

Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the pro-
cess several times.
Always disconnect the power plug before starting to clean the device hous-
ing with a damp cloth. If necessary, the housing can be cleaned using a
cloth moistened with clean water with a little mild soap applied. Never use
any solvents or aggressive cleaning agents.
16