Camera Led Indicators - Panasonic KX-HN7001 Guia De Instalacion

Camera LED indicators

You can use the LED indicators to confirm the camera's status.
Camera LED indicator
Off
Green or amber, blinking quickly -
off for 1 second
Amber, lit
Green, lit
Green, blinking quickly
Red, lit
Red, blinking quickly
Amber, blinking slowly
Green, blinking slowly
Red, blinking slowly
*1 You can configure the camera so that its LED indicator does not light during normal
operation. For more information, refer to the User's Guide (page 32).
*2 The LED indicator lights in amber for 5 seconds after the power is turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after pressing MSETUPN for 3
seconds.
For assistance, please visit http://shop.panasonic.com/support
HN7001_(en_en)_0209_ver.140.pdf 21
Status
R No power
R More than 5 seconds have passed since turning on the
power when the camera is not registered to the access
point
R LED indicator is turned off
*1
Camera is on
Not registered to the access point
*3
good
Registration successfully completed or signal level is
*3
strong
Camera is searching for an access point
Registration failed, signal level is weak
*1
motion
*1
Streaming data
*1
Battery is running low
Registration mode, updating
Camera is out of range of the access point
Setup
*1
*2
, or signal level is
*1
*3
, or detecting
*1 *3
,
2018/02/09 11:33:53
21