Disassembling The Camera - Panasonic WV-CF102E Instrucciones De Operación

■ Disassembling the Camera

1. Peel off the protection sheet from the
top cover.
Don't remove completely as this protects
the dome during installation.
2. Remove the top cover.
• Adjust the marker on this unit to "I" on
the top cover, and turn the top cover
counterclockwise to remove it.
• Turn the "fingerplate" of the camera in
the direction of the arrow as shown in
the drawing, and the top cover can be
removed.
• The clear dome cover and the inner
dome cover are joined into a single unit.
Therefore, never try to remove them.
The mounting requirements are shown as
follows.
Mounting Model
place
Ceiling/wall (Direct mounting)
12
● To mount the camera directly on
the wall/ceiling
1. Prepare the mounting space.
2. Place the template (standard acces-
sories) onto the wall/ceiling and mark two
screw positions and cable access hole
with a pen.
3. Mount the camera onto the wall/ceiling
with 2 screws (procured locally).
4. Fasten all of the mounting screws.
● To mount the camera on a gang
junction box
1. Install the gang junction box onto the
wall/ceiling.
2. Mount the camera onto the gang junction
box with 2 screws (procured locally).
3. Fasten all of the mounting screws.
Recommended screw and
tightening torque
M4, 1.6N·m{16kgf·cm}
Number of Minimum pullout
screws strength
2 pcs. 196 N/pc.{20 kgf/pc.}