Setup
Part names and functions
Access Point
A
A LED indicator
B microSD card slot
C MSETUPN
Access point LED indicator
You can use the LED indicator to confirm the access point's status.
Access point LED indicator
Off
Amber, lit
Amber, blinking quickly
Green, lit
Green, blinking slowly
Green, blinking quickly
Green, lit « Amber, lit
(alternating)
Red, lit
*1
You can configure the access point so that its LED indicator does not light during normal
operation. For more information, refer to the User's Guide (page 32).
*2
It may take some time for the access point to finish starting up.
For assistance, please visit http://shop.panasonic.com/support
18
HN7001_(en_en)_0209_ver.140.pdf 18
B
C
D
D DC jack
E LAN jack
F Reset button
Status
No power, or LED indicator is turned off
Power on until start up completed
IP address is not obtained, or Ethernet cable is not
connected to the router
Power is on (normal operations)
completed for the camera or smartphone
Registration mode, updating
Obtaining an IP address, or accessing a microSD card
*2
Starting up
Registration failed
E
F
*1
*1
, or registration
*1
2018/02/09 11:33:53