o 2-block/3-channel mode: 4 groups of 2 blocks, each block consisting of 3 channels, each fixture has 12
channels
CH
CH
10-12
10-12
o 1-block/3-channel mode: 8 groups of 1 block, each block consisting of 3 channels, each fixture has 24
channels
CH
CH
22-24
19-21
o 8-block/6-channel mode: 1 group of 8 blocks, each block consisting of 6 channels, each fixture has 6 channels
CH
CH
1-6
1-6
o 4-block/6-channel mode: 2 groups of 4 blocks, each block consisting of 6 channels, each fixture has 12
channels
CH
CH
7-12
7-12
o 2-block/6-channel mode: 4 groups of 2 blocks, each block consisting of 6 channels, each fixture has 24
channels
CH
CH
19-24
19-24
o 1-block/6-channel mode: 8 groups of 1 block, each block consisting of 6 channels, each fixture has 48
channels
CH
CH
42-48
37-42
The channels of each group will run according to the preset channel mode (3-channel or 6-channel mode). If two
or more VDPLW2300s are set in the same group mode and channel mode, the DMX address codes of these
VDPLW2300s can also be set as the same code. Of course they will run all the same.
Master / Slave Running Mode
Connect two or more VDPLW2300s (without DMX signal) and set one or more VDPLW2300s into sound-
activated mode (see "Non DMX Running Modes").
NOTE: The master device will be randomly selected as one of the sound-activated fixtures. The master device is
not fixed and can switch to another sound-activated fixture at any time.
• DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDP250CC3. Multiple VDP250CC3s can be linked through serial linking. The linking cable
should be a two-core screened cable with XLR input and output connectors.
VDLPW2300_v2
CH
CH
7-9
7-9
CH
CH
16-18
13-15
CH
CH
1-6
1-6
CH
CH
7-12
7-12
CH
CH
13-18
13-18
CH
CH
31-36
25-30
CH
CH
4-6
4-6
CH
CH
10-12
7-9
CH
CH
1-6
1-6
CH
CH
1-6
1-6
CH
CH
7-12
7-12
CH
CH
19-24
13-28
7
CH
CH
1-3
1-3
CH
CH
4-6
1-3
CH
CH
1-6
1-6
CH
CH
1-6
1-6
CH
CH
1-6
1-6
CH
CH
7-12
1-6
HQPOWER