Kenwood DNX8935 Guia De Inicio Rapido página 26

Installation
Ñ Removing the unit (DNX893S, DNX7160BTS,
DNX693S, DNX5160BTS)
1) Remove the trim plate by referring to step 1 in "Removing
the trim plate".
2) Insert the two extraction key (accessory 4) deeply into the
slots on each side, as shown.
3) Lower the extraction key toward the bottom, and pull out
the unit halfway while pressing towards the inside.
✎
NOTE
• Be careful to avoid injury from the catch pins on the
extraction key.
4) Pull the unit all the way out with your hands, being careful
not to drop it.
26
Ñ Connecting the system and external components
4
12 10 9
1
2
3
4
1 iDatalink connector
(DNX893S/ DNX773S/ DNX693S/ DNX573S only)
2 AV Audio output (ø3.5 mini jack)
3 FM/AM antenna input
4 When connecting to an external amplifier, connect its
ground wire to the car's chassis to avoid damaging the
unit.
Rear Audio Preout (Left; White, Right; Red)
Front Audio Preout (Left; White, Right; Red)
Subwoofer Preout (Left; White, Right; Red)
Visual Output (Yellow)
Front view camera input
(Yellow)
Rear view camera input
(Yellow)
11
8 7 6
5
5 Accessory =: Steering remote harness
(DNX7160BTS/ DNX5160BTS only)
Connect to vehicle's steering remote harness. Contact
your KENWOOD dealer for details.
6 SiriusXM Connect Vehicle Tuner connector
(DNX893S/ DNX773S/ DNX693S/ DNX573S only)
7 AV-IN (CA-C3AV; Optional Accessory) input
(AV-IN2: DNX7160BTS/ DNX5160BTS)
8 Accessory 0: GPS Antenna
9 Accessory 3: Bluetooth Microphone
p HDMI/MHL input
MHL maximum power supply current : 5 V = 900 mA
When you connect the cable to HDMI/MHL terminal,
remove the fixture. After connecting the cable, put the
fixture again.
HDMI/ MHL connector
Fixture
q AV-IN1 input (Visual; Yellow, Left audio; White, Right
audio; Red)
(DNX7160BTS/ DNX5160BTS only)
w TV tuner remote output
(DNX7160BTS/ DNX5160BTS only)