Kenwood DNX8935 Guia De Inicio Rapido página 27

Installation
Ñ Connecting wires to terminals
Connect to the vehicle's parking
brake detection switch harness.
PRK SW
Light Green (Parking sensor wire)
For best safety, be sure to connect
the parking sensor.
Ignition key switch
ACC
Red (Ignition wire)
Car fuse box
Black (Ground wire) ¤
(To car chassis)
Battery
Fuse (15A)
Accessory 1
Purple/White (Reverse sensor wire)
Light Blue/Yellow
(Steering remote control wire)
Yellow (Battery wire)
Orange/White
(Dimmer control wire)
Blue (Antenna control wire)
Blue/White (Power control wire)
Speaker impedance: 4-8 Ω
White
+
To front left speaker
White/Black
Gray
+
To front right speaker
Gray/Black
Green
+
To rear left speaker
Green/Black
Purple
+
To rear right speaker
Purple/Black
If no connections are made, do not let the cable
come out from the tab.
Connect to vehicle's reverse lamp harness when using the
optional rear view camera.
REVERSE
To steering remote
STEERING WHEEL
To use the steering wheel remote control feature, you need an
REMOTE CONT
REMOTE INPUT
exclusive remote adapter (not supplied) matched to your car.
To car light control switch
ILLUMI
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the power
ANT CONT
terminal for the booster amplifier of the film-type antenna.
(Max. 300mA, 12V)
When using the optional power amplifier, connect to its
power control terminal.
P. CONT
English | 27