Quick HECTOR Serie Manual Del Usuario página 11

BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING:
the Quick
Do not use the equipment for other purposes.
personal injury, caused by a faulty use of the equipment.
extreme weather conditions (storms).
Check that there are no swimmers nearby before dropping anchor.
For improved safety we recommend installing at least two anchor windlass controls in case one is accidentally damaged.
We recommend the use of the Quick
Secure the chain with a further device before starting the navigation.
After completing the anchorage, secure the chain or rope to fi xed points such as chain stopper or bollard.
To prevent accidental releases, the anchor must be secured. The windlass shall not be used as the only securing device.
Isolate the windlass from the power system during navigation (switch the circuit breaker off) and lock the chain securing it to
a fi xed point of the boat.
THE PACKAGE CONTAINS: windlass - handle - bolts and screws (for assembly) - drill template - user's manual - conditions of warranty
TOOLS REQUIRED FOR INSTALLATION:
hexagonal wrenches: 13 mm and 17 mm.
"QUICK ® "ACCESSORIES RECOMMENDED: anchoring RL control board (mod. 800) - Waterproof hand helds R/C (mod. HRC1002)
- Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC1102M and CHC1202M) - Radio control
(mod. 1302,1352; 02, 302).
INSTALLATION REQUIREMENTS:
upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appropriately (a lack
of parallelism could result in a loss of motor power). The deck thickness must be included among the fi gures listed in the table. In cases
of other thicknesses it is necessary to consult a Quick
and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE: When the ideal position has been established, drill four holes using the drilling template provided. Remove ex-
cess material from the chain through hole, ensuring the free passage of the chain or rope. Screw the stud bolts, using the short threaded
end, onto the base. Apply a medium grade locking product onto the thread. Position the windlass lowering it from above deck. Fix the
windlass by screwing the nuts onto the fi xing studs. For an improved watertight seal it is advisable to apply silicone around the entire
outside edge of the base. Connect the supply cables from the windlass to the battery.
C
B
A
WARNING: before wiring up, be sure the electrical cables are not live.
HECTOR 700/1000/1500W - REV006A
® windlasses are designed to weigh the anchor.
Always deactivate the windlass when not in use.
® hydraulic-magnetic switch as the motor safety switch.
drill and drill bits: Ø 11 mm (7/16") - Ø 24 mm (15/16") and Ø 43 (1" 11/16) hollow mill;
the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that the
® retailer. There must be no obstacles under deck to the passage of cables, rope
max 5 mm
(3/16")
45°
INSTALLATION
®
" DEALER.
Quick ® shall not be held responsible for damage to equipment and/or
The windlass is not designed for the loads that might occur in
40 cm
(16")
GB
11