Specifications
Video recording system
Rotary 2 head helical scanning system
Video head
Double azimuth 4 head
Tuner system
Frequency synthesized tuner
TV system
M
Video signal system
NTSC color system, 525 lines,
60 fields
Usable cassettes
VHS video cassette
Recording/Playback time
SP: 3.5 hours with T-210 tape
LP: 7 hours with T-210 tape
SLP:10.5 hours with T-210 tape
Tape speed
SP: 33.35 mm/sec
LP: 16.67 mm/sec
SLP:11.12 mm/sec
Fast-forward/
Approx. 110 seconds
Rewind time
with T-120 tape
Channel coverage VHF: 2 to 13
UHF: 14 to 69
CATV: 5A, A-5 to A-1, A to W,
W+1 to W+84
RF output
VHF channel 3 or 4 (switchable), 66 dBµ
Video input
1.0Vp-p, 75 ohm, unbalanced
Video output
1.0Vp-p, 75 ohm, unbalanced
Horizontal resolution
230 lines (at SP)
Video S/N
50dB (nominal)
Audio track
3 tracks (Hi-Fi sound 2 tracks,
Normal sound 1 track)
Audio input
–8dBs, 50K ohm
Audio output
–8dBs, less than 1K ohm
Audio frequency response
normal: 100Hz-10kHz (at SP)
Hi-Fi:
20Hz-20kHz (at SP)
Audio S/N
normal: more than 42 dB (at SP)
Hi-Fi dynamic range
more than 90 dB (at SP)
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Operating temperature
5°C to 40°C
Power requirements
120V AC, 60Hz
Power consumption
12 W
TYP 2.5W (standby mode)
360(W) × 232.5(D) ×94(H) mm
Dimensions
× 13
1
(14
/
4
Weight
3.2 kg (7.1 lbs.)
Supplied accessories
Batteries (R03, size AAA) (2)
Remote control (1)
Antenna cable (1)
Audio/video cable (1)
Design and specifications are subject to change without
notice for the purpose of performance improvement.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technical
for help.
Caution
Modifications or adjustment to this product, which are not
expressly approved by the manufacturer, may void the
user's right authority to operate this product.
× 3
1
3
/
/
in.)
8
4
30
ENGLISH