Putting Into Operation - SATA Air star C Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 117
Operating manual SATA air star C
EN
■ Tighten both ends of the head band [6-2] and [6-4] until half
mask [6-3] is completely fitted to the face.

9.5. Putting into operation

■ Connect spray gun compressed air tube [1-5] / [2-5] to the air connec-
tion of the spray gun.
■ Connect spray gun compressed air tube to the air connection [7-9] / [2-
8].
■ Connect breathing air tube [1-2] / [2-2] to the air connection [7-7] / [8-
4].
Option
■ Connect breathing air tube [1-2] / [2-2] to the air connection [1-
3] / [2-3] of the respiratory humidifier top air [1-4] / [2-4].
■ Connect compressed air supply [1-7] / [2-6] to the air connection [7-
6] / [8-3] of the belt unit.
■ Open the cut-off valve of the air connections [1-11] / [2-8] and [2-9].
9.6. Setting the breathing air supply
Note!
The protection provided by the half mask is only ensured if the following
criteria are met.
Standard version
■ The pressure gauge [1-13] must be checked every time the spray
gun is put into use. The pressure gauge must be in the green range
during the entire operation. Increase operating pressure if necessary.
Alternative model
■ The minimum operating pressure on the filter unit [2-7] must be 4 bar.
Adjust operating pressure if necessary.
Note!
The belt unit is equipped with a control valve [7-2] / [8-2]. A breathing
air supply with fixed parameters independent of specific requirements
can be set with the help of this control valve.
■ Open cut-off valve on air connection [1-11] / [2-9].
■ Set breathing air supply via control valve [7-2] / [8-2].
110

Publicidad

Tabla de contenido
loading

Tabla de contenido