Note!
If different persons are using the same half mask, it should be disinfect-
ed after each use.
Use "Incidur" by the Heinkel company for disinfection.
The half mask should be cleaned after no later than six months, even if it
has not been in use.
The half mask can be easily dismantled without tools for cleaning and for
replacing defective parts. The half mask must be cleaned of sweat and
condensate ever time after it has been used.
■ Thoroughly clean the half mask [11-4] and rubber seal [11-1] with the
enclosed cleaning cloths.
■ After cleaning, check the half mask for any damage.
11.2. Storage
Attention!
Physical damage from incorrect storage
Incorrect storage conditions can cause premature damage to the half
mask.
→ Avoid exposure to direct sunshine.
→ Keep away from sources of heat.
→ Make sure the storage area is well ventilated.
→ Maintain a relative humidity of < 90 %.
→ Only store the half mask in dry state.
New and originally packed half masks can be stored for 6 years under the
stated storage conditions (see chapter 7).
Masks that are in use must be kept in the provided hygiene boxes, in
special storage cabinets or other suitable containers to protect them from
dust and vapours.
12. Disposal
Dispose of the half mask as recyclable material. To avoid damage to the
environment, dispose of the half mask separately from the air filters in an
appropriate manner. Comply with local regulations!
13. After Sale Service
Accessories, spare parts and technical support may be obtained from
your SATA dealer.
Operating manual SATA air star C
EN
113