2) Attach the wireless adapter cable plug to the lower socket on the joint module (see fig. 3).
INFORMATION: Observe the plug direction.
→ The blue LED on the BionicLink has to light up. If it does not, charge the orthosis battery
or check the connecting cable.
3) Loop the free end of the hook-and-loop strap around the joint module, thread it through the
plastic ring and pull it tight (see fig. 4).
7 Use
1) Launch the adjustment software on the computer (C-Soft version 2.6 or later).
2) Start the connection process in C-Soft.
3) The adjustments can be carried out.
INFORMATION: The orthosis wearer must stand or sit comfortably and calmly during
the adjustment.
→ The blue LED on the BionicLink flashes during the data transfer process.
INFORMATION
The range of the Bluetooth® connection is around 10 metres, but this can vary depending on the
local conditions. The leg prosthesis should not be taken outside of this range while it is connec
ted.
INFORMATION
If the leg orthosis is outside the transmitter's range or if the transmission path is shadowed (e.g.
by steel or reinforced concrete), the connection may be interrupted. This will be indicated by the
warning "connection interrupted" on the computer.
8 Disposal
In some jurisdictions it is not permissible to dispose of these products with unsorted
household waste. Disposal that is not in accordance with the regulations of your country
may have a detrimental impact on health and the environment. Please observe the
instructions of your national authority pertaining to return and collection.
9 Legal information
9.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
9.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi
fy the conclusion that the denotation in question is free of third-party rights.
9.3 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out
16 | Ottobock