Instrument Alarm; Menu Functions; Calling The Info Mode - Dräger X-am 5100 Instrucciones De Uso

3.6.5 Battery main alarm
The alarm is indicated by an intermittent alarm
message:
Flashing special symbol » « on the right side of
the display:
The battery main alarm cannot be acknowledged or cancelled:
The instrument is automatically switched off again after 10 seconds.

Before the instrument is switched off, the visual, audible and

vibration alarms are activated for a short time.
3.6.6

Instrument alarm

The alarm is indicated by an intermittent alarm
message:
Special symbol » « displayed on the right side of
the display:
The instrument is not ready for operation.

Commission maintenance personnel or DrägerService to rectify

the error.
4

Menu functions

4.1

Calling the Info Mode

In measuring mode, press the

If any warning or fault messages are present, the corresponding

information or error codes will be displayed (see the Technical
Handbook).
Press the key successively for the next display. The TWA and
 OK
STEL peak values and exposure values will be displayed.
If no key is pressed for 10 seconds, the instrument reverts

automatically to measuring mode.
Dräger X-am 5100
key for approx. 3 seconds.
OK
4.2 Calling the Info-Off Mode
When the instrument is in a deactivated state, press the

The name of the gas, measuring unit and measuring range

limit value are displayed.
Pressing the key again exits the Info Off mode (or via timeout).

4.3 Quick Menu
Bump test, see "Performing the bump test" on page 22
Fresh air adjustment, see "Performing a fresh air calibration"
on page 26
Display and deletion of the peak values
Menu functions
key.
25