Special State; Blocking Alarm; Calling The Quick Menu - Dräger X-am 2800 Instrucciones De Uso

To acknowledge an alarm:
1. Select .
OK

4.6.3 Special state

The operation signal is deactivated during a special state. Special states are
displayed by the following visual signals:
– Yellow LED flashing – 'warm-up 1' special state
– Yellow LED continuously illuminated – general special state
No alarms are issued during a special state.
The special state is exited by resolving the potential error, in the event of an
intact gas detector, by switching to normal measuring mode, or automatically
after approx. 1 minute.

4.6.4 Blocking alarm

The blocking alarm protects the CatEx sensor.
If the measuring range is exceeded significantly at the CatEx channel (very high
concentration of flammable substances), a blocking alarm is triggered. This
CatEx blocking alarm can be acknowledge by switching the gas detector off and
then on again in fresh air.
For more details, refer to the technical manual.
4.7

Calling the Quick menu

The Dräger CC-Vision software can be used to save preferred features in the
Quick menu.
Possible features:
– Fresh air calibration
– Bump test
– Delete peak values
– Bluetooth
To open the Quick menu:
1. Press 3x in measuring mode.
2. Press to scroll through the available features.
3. Press to call the selected feature.
OK
®
X-am 2800
®
connection
|
Operation en
49