Disposal; Troubleshooting - Waeco CoolMatic HDC-270 Instrucciones De Montaje Y De Uso

_HDC270.book Seite 43 Montag, 18. Oktober 2010 8:12 20
HDC-270
10

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the product, ask your local recycling
M
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
11

Troubleshooting

Compressor does not run
Problem
U = 0 V
KL
U = U
KL ON
Start attempt with
= U
U
KL OFF
Start attempt with
= U
U
KL ON
Electric circuit between
the pins in the compres-
sor interrupted
U Voltage between the positive and negative terminals of the electronics
KL
U Cut-in voltage of the electronics
ON
U Cut-off voltage of the electronics
OFF
Possible cause
There is an interruption in the
battery – electronics connection
Main switch faulty (if installed)
Additional supply line fuse has blown
(if installed)
Battery voltage is too low
Loose cables
Poor contact (corrosion)
Battery capacity too low
Cable cross section too small
Ambient temperature too high
Insufficient ventilation
Condenser is dirty
Fan defective (if installed)
Defective compressor
Disposal
Remedy
Establish a connection
Replace the main switch
Replace the supply line
fuse
Charge the battery
Establish a connection
Replacing the battery
Change the cable (see
table on page 37)
–
Move the refrigerator to
another location
Clean the condenser
Replace the fan
Replace the compressor
43