Power Failure; Cooktop Use; Important; Sealed Surface Burners - Sears Kenmore 664.7511 Serie Manual De Uso Y Cuidado

WARNING
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners
when control knobs are turned to LITE.
Before setting a control knob, place filled cookware on
the grate. Do not operate a burner using empty cookware
or without cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to LITE.
All surface burners will click. Only the burner with the
control knob turned to LITE will produce a flame.
2. Turn knob to anywhere between Hi and Lo.
REMEMBER: When range is in use or (on some models)
during the Self-Cleaning cycle, the entire cooktop area may
become hot.
IMPORTANT: When cooktop is in use, the Self-Cleaning cycle
will be disabled. Attempting to activate the Self-Cleaning
cycle during cooktop use will cause an error tone to sound
and the Cooktop On indicator light to flash. If you turn on the
cooktop when the Self-Cleaning cycle is in use, it will disable
the Self-Cleaning cycle and "END" will be displayed.

Power Failure

In case of prolonged power failure, the surface burners can
be lit manually. Hold a lit match near a burner, and then
turn knob counterclockwise to LITE. After burner lights, turn
knob to setting.
8

COOKTOP USE

Fire Hazard

Sealed Surface Burners

E
A. Burner cap
B. Gas tube opening
C. Burner base
IMPORTANT: Do not obstruct the flow of combustion
and ventilation air around the burner grate edges.
Burner Cap: Always keep the burner cap in place when using
a surface burner. A clean burner cap will help avoid poor
ignition and uneven flames. Always clean the burner cap after
a spillover and routinely remove and clean the caps according
to the "General Cleaning" section.
Alignment: Be sure to align the gas tube opening in the burner
base with the orifice holder on the cooktop and the igniter
electrode with the notch in the burner base.
Gas Tube Opening: Gas must flow freely throughout the gas
tube opening for the burner to light properly. Keep this area
free of soil and do not allow spills, food, cleaning agents,
or any other material to enter the gas tube opening. Keep
spillovers out of the gas tube opening by always using a
burner cap.
A
A. 1" to 1 1
B. Burner ports
Burner Ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame
is blue in color, not yellow. Keep this area free of soil and do
not allow spills, food, cleaning agents, or any other material to
enter the burner ports.
To Clean:
IMPORTANT: Before cleaning, make sure all controls are OFF
and the cooktop is cool. Do not use oven cleaners, bleach, or
rust removers. Do not wash in the dishwasher.
1. Remove the burner cap and the burner base, and clean
according to "General Cleaning" section.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown.
A
B
C
D
D. Igniter electrode
E. Orifice holder
B
/ " (2.5 cm to 3.8 cm)
2