Caring For And Maintaining The Cam1000 / Bsc01; Warranty; Disposal - Dometic CAM1000 Instrucciones De Montaje

CAM 1000 / BSC 01
Fault
No picture, but the
warning tone sounds.
Frequent wrong indica-
tion at the end of the
vehicle when driving
right in a curve.
Frequent false alarms on
uneven surfaces
10

Caring for and maintaining the CAM1000 / BSC01

A
NOTICE! Damage hazard
Do not use sharp or hard objects or cleaning agents for cleaning as these may damage
the product.
➤ Occasionally clean the product with a damp cloth.
11

Warranty

The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see dometic.com/dealer) or your retailer.
For repair and warranty processing, please send the following items:
• Defect components
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
12

Disposal

➤ Place the packaging material in the appropriate recycling waste bins wherever possible.
EN
Caring for and maintaining the CAM1000 / BSC01
Cause
The monitor receives no video
signal. CAM1000 is connected
to the wrong input.
The cinch adapter has a loose
contact or is defective.
The camera points too far back.
Due to the 180° angle of view of
the camera, the image moves
from back to front and the system
also detects non-relevant
objects.
Vehicle parts, which move rela-
tive to the camera, are captured
as an object, e.g. box body
Solution
Check the camera channel used.
It must be C3.
Check cinch adapter.
Align the camera as perpendicu-
lar as possible. The red test field
should stop at about 8 m from
the front of the vehicle..
Find the corresponding vehicle
parts (e.g. front edge of the box
body) and take them out of the
active area by readjusting the
camera. Use the reference lines
as a tool for this purpose (see
also fig. c).
13