Using The Cam1000 / Bsc01; Detection Range; Test Indicator When Switching On - Dometic CAM1000 Instrucciones De Montaje

CAM 1000 / BSC 01
➤ Connect the control cable of the GPS receiver (blue) with the blue CAM3 control cable of the
monitor. This line is used to switch the monitor on/off.
✓ The system will automatically be activated and deactivated via the GPS signal at approx.
40 km/h.
➤ Connect the control cable of the monitor and the camera for the reverse gear (green) with the
vehicle's reverse gear signal.
✓ The camera provides an image and object detection is still active, but the warning sound is
deactivated.
8

Using the CAM1000 / BSC01

I
NOTE
On the initial start-up the GPS receiver must save the satellite position. This may take up
to 5 minutes.
8.1

Detection range

The detection range of the CAM1000 / BSC01 is divided into two zones:
• Visible area: depending on mounting height in operating mode A or B
• Active area: 8 m x 4 m
I
NOTE
The view of the camera into the detection area must not be obscured by vehicle parts.
Objects may not be detected.
8.2

Test indicator when switching on

See fig. b
I
NOTE
The video system switches to standby as soon as the ignition is switched on. The sys-
tem is activated depending on the speed from a speed of less than 40 km/h. The cam-
era image appears.
The test indicator allows the camera to be correctly aligned with the front of the vehicle. The refer-
ence line (fig. b 1) shall be at least in alignment with the front of the vehicle. The active area
(fig. b 2) is marked as a red area in the video for 6 seconds.
I
NOTE
In night mode with ambient lighting below 50 lux, the camera switches to black and
white mode. This is necessary to optimize object detection even in poor lighting con-
ditions.
EN
Using the CAM1000 / BSC01
11