Peavey XR684F Manual De Operación página 10

Effects Section
16
17
Store: This button enables you to store a custom effects setting to one of four preset locations (Store 1–Store 4).
16.
Start with one of the twelve presets provided. Adjust the two parameter controls (Time/Size and Color/Tone) to your
desired settings. When you are satisfied with the new settings‚ push the Store button once. The corresponding LED
will start blinking. Now‚ twist the Preset Selector knob to one of the four locations provided and push the Store
button again. This action stores your settings and the LED stops blinking. When recalling any one of these four user-
defined locations‚ keep in mind that the parameter settings are stored internally and may differ from where the
actual knobs are physically set.
Store LED: This yellow indicator blinks to indicate that you are in the Store mode. (See the above paragraph.)
17.
Effects Peak LED: This red LED illuminates to indicate 6 dB of headroom before the signals being sent to the
18.
effects circuit are clipped. Ideally‚ you want this LED to light only occasionally. An occasional blink indicates that
your levels are set optimally. Listen carefully to the output to determine the final setting.
Preset Name
1 Plate Rev
2 Spring Rev
3 Room Rev
4 Room Rev2
5 Hall Rev
6 Lg Hall Rev
7 Short Dly
8 Long Dly
9 Chorus
10 Rvb/Dly1
11 Rvb/Dly2
12 Rvb/Dly3
13 Store4
14 Store3
15 Store2
16 Store1
19
18
20 21
Time/Size
Time
Time
Time
Time
Time
Time
Time: 40–1100 ms
TIme: 150–4000 ms
Rate
Time
Time
Time
User-defined location
User-defined location
User-defined location
User-defined location
10
22 23
Color/Tone
Damping (High Frequency)
Damping (High Frequency)
Damping (High Frequency)
Damping (High Frequency)
Damping (High Frequency)
Damping (High Frequency)
Feedback: 0–50%
Feedback: 0–50%
Depth: Best Set Full CCW
Dly Time: 100–950 ms
Dly Time: 100–950 ms
Dly Time: 100–950 ms