HP Scanjet 7000 Guía De Instalación Inicial página 13

(continued)
Icon
2
3
4
5
6
7
NOTE: For information about status and error messages, see the troubleshooting
information in the scanner User Guide.
Scanner lamp setting
The scanner supports two modes of lamp operation:
• In Power Save mode, the scanner lamp times out and turns off automatically after
about 15 minutes of inactivity. If the scanner lamp has turned off and you want to
scan, either press the Power Save button or load originals into the document feeder.
• In Instant Lamp On mode, the scanner lamp times out and turns off automatically
after about 15 minutes of inactivity, but it remains warm and ready to scan.
To switch from Power Save mode to Instant Lamp On mode, select the Enable Instant
Lamp On check box on the Settings tab of the HP Scanner Tools Utility. To switch back
to Power Save mode, clear the Enable Instant Lamp On check box.
Button name Description
OK/Select Allows you to scroll the list of scan profiles, view
their details, and specify the number of
copies.
•
•
Scan Simplex Starts a one-sided scan or copy.
Scan Duplex Starts a two-sided scan or copy.
Tools Opens the HP Scanner Tools Utility where you
can perform the following tasks:
•
•
•
Cancel Cancels a scan or copy in progress.
Back Returns you to the list of profiles when you are
viewing profile details or specifying number of
copies for a copy profile. Pressing
specifying number of copies cancels your
selection.
Press and to scroll through profiles
or specify number of copies.
Press OK to view scan profile details,
return to the list of profiles when viewing
scan profile details, and to specify the
number of copies for a copy profile.
Configure the list of profiles on the scanner
front panel
Create scan profiles that use third-party
scanning software
View information about scanner settings,
status, and maintenance
Scanner overview
when
9