How To Use The Accessories; Important Application Instructions - Silvercrest 37702 Manual De Instrucciones

How to Use the Accessories

Important application instructions

Cleaning of Textiles
Prior to treatment with the steam cleaner, always
check the reaction of the textiles in an inconspic-
uous location: Steam heavily at first, then let dry
and then check for colour or shape changes.
Cleaning of Coated or Lacquered Surfaces
Be careful when you clean kitchen and living
room furniture, doors, parquet, lacquered or
plastic-coated surfaces. The wax, furniture
polish, plastic surfaces or paint can come loose
or stains can be created. Therefore, always
clean these surfaces with a steamed cloth only.
Caution
Never direct the steam jet at glued edges as the
edge band may loosen. Do not use the steam
cleaner on unsealed wooden or parquet floors.
Cleaning of Glass
In case of low outside temperatures, especially
in the winter, warm up the window pane by slight-
ly steaming the entire glass surface. This will
prevent tensions on the surface which might lead
to glass breakage.
Caution
Do not direct steam onto the sealed locations of
the window frame to prevent damage.
Steam gun (B1)
You can use the steam gun without any addition-
al accessories, e.g.:
–
to remove odours and wrinkles from hanging
clothes by steaming them at a distance of 10
to 20 cm.
–
to remove dust from plants. Here, keep a dis-
tance of 20-40 cm.
–
for moist dusting, by briefly steaming the
cloth and wiping the furniture with it.
18 English
Detail nozzle (C1)
The closer this nozzle is to the contaminated ar-
ea, the higher the cleaning effect, as the temper-
ature and the steam are highest at the nozzle
output. Especially suited for cleaning fittings,
drains, sinks, toilets, blinds and heaters. Moisten
stubborn limescale with vinegar, and allow to re-
act for approximately 5 minutes.
Round brush (C2)
Attach the round brush directly to the detail noz-
zle. Especially well-suited for hard to access lo-
cations, such as fittings or drains.
Caution
Not suited for the cleaning of sensitive surfaces.
Manual nozzle (D1)
Pull the terry cloth (D2) cover over the manual
nozzle. Especially well-suited for small washable
areas, shower stalls, mirrors or furniture cloth
material.
Floor nozzle (F1)
Suited for all washable wall and floor coverings,
e.g. stone floors, tiles and PVC floors. Work
slowly on very dirty surfaces to allow the steam
to act on the dirt for a longer period of time.
Note:Detergent residue or care emulsions that
are still present on the surfaces to be cleaned,
can lead to smears when steam cleaned. How-
ever, these will disappear with repeated cleaning
procedures.
Illustration
Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth (F3) the long way and
place the floor nozzle (F1) on top of it.
2 Open holding clamps (F2).
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
Parking the floor nozzle
Illustration
During work breaks:
Hook the floor nozzle (F1) into the parking
position (A6).