5.7. Entire machine
The entire machine must be cleaned on a regular basis.
The gears, motor and electrical components must not be cleaned with high-pressure cleaners.
Only clean the control box with a damp sponge / cloth!
6. Setup and spare parts list
A diagram of the machine and its spare parts can be found at the end of this document.
7. Residual risks
Risks for persons:
under the following circumstances, the safety of persons and material objects can be endangered:
• if the safety devices on moving parts have been removed.
• if any damage to the control system is not repaired immediately.
• if untrained personnel are working on electronic parts.
• if the machine is activated before being secured properly to a wall or pillar (for testing or demonstration reasons).
The following points summarise further measures aimed at protecting against personal and material risks:
• ensure that the machine, the control devices and the brushes are not damaged during transport and installation.
• mount the machine in a place that is well ventilated and free from electromagnetic interference.
• the personnel responsible must be trained in the use and maintenance of the machine.
Risk for animals:
under the following circumstances, the safety of the cattle can be endangered:
• the animals are not yet fully mature.
• the cattle are of an unusually small breed.
– > the switch-off resistance can be set too high.
• the animals have collars and/or tail hairs that are too long.
• the animals' hides are more than 5 cm long.
• the customer has not protected the current-carrying parts (cables) adequately / at all against biting.
Important: the length of the cattle's tail hairs must not exceed 5 cm!
40