Other Functions; Using The Rotary Commander (Xr-C5090 Only) - Sony XR-C5090 Manual De Instrucciones

Changing the displayed items
Each time you press (DSPL), the display
changes between the frequency and the clock.
If you cannot tune in a preset
station
Press either side of (SEEK/AMS)
momentarily to search for the station
(automatic tuning).
Scanning stops when a station is received.
Press either side of (SEEK/AMS) repeatedly
until the desired station is received.
Note
If the automatic tuning stops too frequently, press
(LCL) to light up "LCL" on the display (local seek mode).
Only the stations with relatively strong signals are tuned
in.
Tip
If you know the frequency, press and hold either side of
(SEEK/AMS) until the desired station is received (manual
tuning).
EN
8

Other Functions

Using the rotary commander
(XR-C5090 only)
The rotary commander works by pressing
buttons and/or rotating controls.
You can control the optional MD/CD unit by
the rotary commander.
By pressing buttons (the SOURCE
and the MODE buttons)
(SOURCE)
Every time you press (SOURCE), the
source changes as follows:
TAPE n TUNER n MD/CD
Pressing (MODE) changes the operation in the
following ways:
• the tape transport direction.
• the band, FM1 n FM2 n FM3 n AM1 n AM2.
• the MD/CD unit.
Tip
You can turn on this unit by pressing (SOURCE) on the
rotary commander.
By rotating the control (the SEEK/
AMS control)
Rotate the control momentarily and
release it to:
• Locate the beginnings of the tracks on the
tape. Rotate and hold the control, and
release it to fast-wind the tape. To
playback, rotate and hold the control
again, and release it.
• Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
• Tune in the stations automatically.
Rotate and hold the control to tune in the
specific station.
(MODE)