Other Functions; Using The Rotary Remote - Sony XR-4750RDS Manual De Instrucciones

Other Functions

Using the rotary remote

The rotary remote works by pressing buttons
and/or rotating controls.
By pressing buttons (the SOURCE
and the MODE buttons)
(SOURCE)
Every time you press (SOURCE), the
source changes as follows:
TAPE ˜ TUNER
Pressing (MODE) changes the operation in the
following ways:
• the tape transport.
• the band, FM1 n FM2 n FM3 n MW n LW.
Tip
You can turn on this unit by pressing (SOURCE) on the
rotary remote.
By rotating the control (the SEEK/
AMS control)
Rotate the control momentarily and
release it to:
• Locate the beginnings of the tracks on the
tape. Rotate and hold the control, and
release it to fast-wind the tape. To
playback, rotate and hold the control
again, and release it.
• Tune in the stations automatically.
Rotate and hold the control to tune in the
specific station.
All manuals and user guides at all-guides.com
By rotating the control while
pushing in (the PRESET control)
Other operations
Rotate the VOL control
to adjust the volume.
(MODE)
Changing the operative direction
The operative direction of controls is factory
preset as in the illustration below.
If you need to mount the rotary remote on the
right side of the steering column, you can
reverse the controls operative direction.
Push in and rotate the control to:
Receive the stations memorized on the
preset buttons.
Press (DSPL) to change the
displayed items.
To increase
To decrease
Press (SEL) for two seconds while
pushing in the VOL control.
Press(MUTE) to
mute the sound.
Press(OFF) to turn
EN
off the unit.
Press (SEL)
to adjust
and select.
11