HomeMatic IP Easy Connect Instrucciones De Montaje página 47

5.3.3 Screw mounting
Do not yet assemble the magnet contact before screw
mounting.
For screw mounting, please proceed as follows:
• Pre-drill the screw holes in the brackets (H) using an appropriate
drill.
• Mark the screw holes for the electronic unit (K) according to the
bracket on the window.
• Mark the screw holes for the magnet contact (I) or, if required, for
the spacer (J) on the window.
• If you are working with hard surfaces you should pre-drill the
holes marked using a 1.5 mm drill.
• Place the bracket of the electronic unit to the desired mounting
location and turn both screws (2.2 x 16 mm) into the screw holes
(see figure 8).
• Insert the electronic unit into the bracket.
• Place the back side of the magnet contact or the spacer to the
desired mounting location and turn both screws (2.2 x 13 mm)
into the screw holes (see figure 8).
• Place the magnet in the bracket and insert the back side into the
housing of the magnetic contact.
When using the spacer, you can simply attach the magnet
contact after installation to the spacer.
Installation
47