Automatic Operation; Manual Operation; Offset Temperature - HomeMatic IP Easy Connect Instrucciones De Montaje

settings of the device before you can connect it to a
Homematic IP Access Point or another Central Control Unit
CCU2/CCU3 (see „10 Restore factory settings" on page 57).
6.1

Automatic operation

In automatic mode, the temperature is controlled in accordance with
the set heating profile. Manual changes are activated until the next
point at which the profile changes. Afterwards, the defined heating
profile will be activated again. To activate the automatic mode, please
proceed as follows:
Select "Auto" via the plus and minus buttons (E and F) in the menu.
•
• Confirm with the menu button.
To confirm, the symbol flashes twice and the device changes back to
automatic mode.
6.2

Manual operation

In manual mode, the temperature is controlled in accordance with
the current temperature set via the push-buttons (E and F). The tem-
perature remains activated until the next manual change. To activate
the manual mode, please proceed as follows:
• Select "Manu" via the plus and minus buttons (E and F) in the
menu.
• Confirm with the menu button.
To confirm, the symbol flashes twice and the device changes back
to manual mode.
6.3

Offset temperature

As the temperature is measured on the radiator thermostat, the tem-
perature distribution can vary throughout a room. To adjust this, a
Configuration menu of the radiatorthermostat
49