Instrument Alarm; Activating The Info Mode; Calling The Quick Menu; Calling The Info-Off Mode - Dräger X-am 5600 Instrucciones De Uso

Instrument alarm

Intermittent alarm:
Special symbol » « displayed on the right side of the display:
– The instrument is not ready for operation.
 Commission maintenance personnel or the Dräger Service Centre to
eliminate the error.

Activating the Info mode

 In measuring mode, press the [OK] key for approx. 3 seconds.
– If any warning or fault messages exist, the corresponding note or error codes
are displayed (see Technical Handbook). Press the [OK] key successively
for the next display. The peak values and the exposure values TWA and
STEV will be displayed.
– If no key is pressed for 10 seconds, the instrument returns automatically to
measuring mode.

Calling the Info-Off mode

With the instrument switched off, press the [+] key for approx. 2 seconds.

The name of the gas, measuring unit, and measuring range limit value are
displayed for all channels.
 Pressing the [+] key again exits the Info Off Mode (or via timeout).

Calling the Quick Menu

 In measuring mode, press the [+] key three times.
– If functions in the quick menu are activated using the PC software "Dräger
CC Vision", you can select these functions using the [+] key. If no functions
have been activated in the quick menu, the instrument remains in measuring
mode.
Possible functions: 1. Bump test
2. Fresh-gas adjustment
3. Delete peak values
 Press the [OK] key to call the selected function.
 Press the [+] key to cancel the active function and to switch to measuring
mode.
– If no key is pressed for 60 seconds, the instrument returns automatically to
measuring mode.
1) The fresh-gas adjustment / zero-point adjustment is not supported by the DrägerSensor DUAL
IR CO , DrägerSensor IR CO or the DrägerSensor XXS O
2 2
sensors can be made with the Dräger CC Vision PC software. A suitable zero gas free from
carbon dioxide and ozone (e.g. N ) must be used.
2
1)
. A zero-point adjustment of these
3
23