Topcom BUTLER OUTDOOR 2010 TWIN Manual De Usuario página 9

Butler Outdoor 2010 - Twin - Triple
2.2 Charger (only Twin or triple version)
Perform the following steps:
Plug the mains adapter into a 230 V socket. Plug the connector into
the adapter jack on the bottom of the charging station.
1
1. Bottom of the charging station
2. Mains adapter cable
2
2.3 Handset activation
Risk of injury due to explosion!
Only use the supplied rechargeable batteries type
(BT-800 2,4V DC).
No need to install the batteries!!
The batteries are already inside the handset. A switch at
the bottom of the handset has disconnect the battery to
avoid discharging. You first have to press this swith to
connect the battery.
1. Remove the cardboard spacer.
2. Press the activation pin according to the direction on the label.
• After activation it takes about 10 seconds before the display
turns on.
3. Remove the label ones the handset is activated.
Save the activation pin in case you want to change the
activation status later (for example when the handset will
not be used for a long time)
Replace the handset in the base station or charging
station after use to prevent the battery fully discharging.
The batteries are designed for permanent charging.
Installation
9