Installing And Removing The Battery Pack; Operating The Trimmer; Switching On And Off - Black and Decker LST560 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles


CAUTION:
only use the appropriate type of cutting line - 080 inch
(2.032 mm) diameter, ROUND nylon line.

CAUTION:
remove any wire, cord, or string-like objects which
could become entangled in the rotating line or spool.
Be particularly careful to avoid any wire which might
be bent outwardly into the path of the appliance, such
as barbs at the base of a chain link fence.

Installing and Removing the Battery Pack


WARNING:
button is engaged to prevent switch actuation before
removing or installing battery.
nOTE: For best results, make sure your battery pack is
fully charged.
To install battery pack: Insert battery pack
housing
as shown in figure J until fully seated and an
 28 
audible click is heard.
Make sure battery pack is fully seated and fully latched into
position.
To remove battery pack: Depress the battery release button
on the battery and pull battery pack out of appliance.
 29 
Figure J
29
Proper Hand Position

WARNING:
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation
of a sudden reaction.
Proper hand position requires one hand on the main
handle 
 3 
and one hand on the auxiliary handle

Switching on and off

To switch the trimmer on, press in and hold the lock
off button
, depress the variable speed trigger
 3 
The trimmer's speed, power, and runtime depend on
how far you press the switch. Lightly depressing the
trigger will result in lower speed and power, but longer
runtime. Fully depressing the trigger will result in
maximum speed and power, but shorter runtime.
Before you begin trimming,
Inspect area to be trimmed and
Make certain the lock-off
into battery
 15 
28
To reduce the risk of serious
To reduce the risk of serious
 6 
.
 1 
To switch the trimmer off, release both the trigger and
the lock off button.

WARNING:
off button in the on position.

Operating the trimmer

With the unit on, angle unit and slowly swing the
trimmer side to side as shown in figure I.
Maintain a cutting angle of 5° to 10°. Do not exceed 10°.
Cut with the tip of the line. To keep distance from hard
surfaces use edge guide
snaps securely into place
Maintain a minimum distance of 24 inches (609.6 mm)
between the guard and your feet as shown in figure L.
Figure K
Figure L
Edging

WARNING:
Edger, stones, pieces of metal and other objects can be
thrown out at high speed by the line. The trimmer and
guard are designed to reduce the danger. However,
MAKE SURE that other persons and pets are at least
100 feet (30m) away. Optimum cutting results are
achieved on edges deeper than 2 inches (50 mm).
Do not use this trimmer to create trenches.
Using the edge guide
in figure M.
Position the edge guide on the edge of the sidewalk or
abrasive surface so the cutting line is over the grass or
.
dirt area to be edged.
To make a closer cut, slightly tilt the trimmer.
Never attempt to lock the on/
. Pull the guide out until it
 13 
MINIMUM
24 INCHES
(610 mm)
When being used as an
 10 
, guide the trimmer as shown
English
9

Publicidad

Tabla de contenido
loading

Tabla de contenido