Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
switches to the pack charging mode. This feature ensures
maximum battery pack life.
A cold battery pack will charge at a slower rate than a warm
battery pack. The battery pack will charge at that slower rate
throughout the entire charging cycle and will not return to
maximum charge rate even if the battery pack warms.
State of charge indicator
The battery is equipped with a state of charge indicator.
This can be used to display the current level of charge in the
battery during use and during charging. It does not indicate
tool functionality and is subject to variation based on product
components, temperature and end-user application.
Checking state of charge during use:
•
Press the state of charge indicator button.
•
The three LEDs will illuminate, indicating the percent of
charge in the battery. See chart in figure B.
•
If LED light does not illuminate, charge battery.
Figure B
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING:
tool or any part of it. Damage or personal injury
could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
INTENDED USE
This string trimmer is designed for residential trimming
applications. DO nOT use under wet conditions or in
presence of flammable liquids or gases.
This string trimmer is a residential appliance. DO nOT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this appliance.
ASSEMBLY AND ADJUSTMENTS
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Never modify the power
To reduce the risk of
Assembly tools required
•
Phillips Screwdriver (not supplied)
•
Hex wrench (supplied)
Installing the guard
WARNING:
WITHOUT GUARD FIRMLY IN PLACE. The guard
must always be properly attached on the appliance to
protect the user.
1. Remove the screw from the guard.
2. Turn the trimmer upside down so that you are looking
down at the spool cap
3. Turn the guard
upside down and slide it fully onto the
13
trimmer head
. Make sure the tabs
11
engage the ribs
on the trimmer head as shown.
18
4. Continue to slide the guard on until you hear it "snap"
into place. The locking tab
housing slot
20
(figure C).
Figure C
13
17
11
5. Using a phillips screwdriver, insert the guard screw and
tighten securely as shown in figure D to complete the
guard assembly.
6. Once the guard is installed, remove the covering from
the line cut-off blade, located on the edge of the guard
Figure D
Assembling the Pole
1. To assemble the pole, line up the upper trimmer pole
and the lower trimmer pole
7
Press down the latching button
pole into the lower pole. Ensure the latching button
engages the latch hole
2. Secure the poles by tightening the middle bolt
the supplied hex wrench
English
NEVER OPERATE appliance
16
.
on the guard
17
19
should snap into the
19
20
18
16
as shown in figure E.
8
and slide the upper
21
.
22
23
24
as shown in figure F.
with
7
Publicidad
Tabla de contenido
