DeWalt DW7187 Manual De Instrucciones página 8

b. Align the blade with the framing square. Turn the side
screw (G) to adjust laser line to edge of framing
square/blade.
NOTE: Repeat Steps 7–9 to ensure accuracy throughout the
travel of the chop stroke.
10. Remove the trigger lock (C) and replace in LPS. Reattach
the 2.5 mm hex wrench (D) in LPS.
C
MAINTENANCE
WARNING: Disconnect the saw from the power source.
For the best laser performance, perform the following mainte-
nance regularly.
• Carefully clean sawdust and debris from laser lens with a cot-
• DO NOT use solvents of any kind, they may damage the
• Avoid touching any sharp points of the blade with your hands
• Dust build-up can block the laser and prevent it from accu-
• Follow miters saw's instruction manual to remove and install
• With blade removed from saw, clean pitch and build-up from
G
D
Repairs
To assure product SAFETY and RELIABILITY, repairs, main-
tenance and adjustment (including brush inspection and
D
replacement) should be performed by authorized service
centers or other qualified service organizations, always using
C
identical replacement parts.
Three Year Limited Warranty
D
E
materials or workmanship for three years from the date of
purchase. This warranty does not cover part failure due to
7
ton swab.
lens.
or fingers.
rately indicating the line of cut.
blade.
blade. Pitch and debris can interfere with the laser and
prevent it from accurately indicating the line of cut.
SPECIFICATIONS
Light Source Semiconductor laser diode
Laser Wavelength 630 – 680 nm Visible
Laser Power <1mw (each beam) CLASS 2
LASER PRODUCT
Power Supply Input: 120–240V AC; 50/60Hz
Output: 3–3.6V DC max.
Operating Temperature 32°F to 104°F (0°C to 40°C)
Storage Temperature 0°F to 185°F (-40°C to 85°C)
Environmental Water Resistant
WALT will repair, without charge, any defects due to faulty