Stihl RMA 410 C Manual De Instrucciones página 12

English
Switch off the motor immediately by
releasing the switch lever if you are
approached.
WARNING
Avoid contact with electrical cables or
wires – risk of electric shock.
Operate the mower at walking pace only
– never run.
Always switch off the motor by releasing
the switch lever before wheeling the
mower over surfaces other than grass,
to and from the grassed area, and when
you remove the grass box.
The mower must not be used for
transporting persons, particularly
children, or objects.
Do not attach objects to the handlebar.
WARNING
During cutting, check the tightness and
the condition of the cutting blade at
regular short intervals with the motor
and blade stopped and the fuse key and
battery removed. If the behavior of the
blade changes during use, switch off the
motor immediately, wait until the cutting
blade stops, remove the fuse key and
battery and check the screw securing
the blade for tightness and the blade for
cracks, wear and damage. Never
examine the cutting blade while the
motor is running. To avoid the risk of
injury from the rotating cutting blade,
never open the ejection chute shield or
remove the grass box while the motor is
running.
If the machine should start to vibrate
abnormally, stop the motor, remove the
fuse key and battery and check for the
10
cause immediately. Vibration is
generally a warning of trouble. Do not re-
start the motor until the cause of the
abnormal vibration is identified and
resolved.
WARNING
If the cutting blade becomes obstructed,
or if there is a blockage in the ejection
chute or in the area of the cutting blade,
always switch off the motor, remove the
fuse key and battery and make sure the
cutting blade has stopped before
cleaning.
In the event of contact with foreign
matter, check the cutting blade for signs
of damage. Do not operate your mower
with a damaged or bent blade shaft or
motor shaft.
WARNING
To reduce the risk of unintentional
rotation of the cutting blade and severe
personal injury or death, always switch
off the motor and remove fuse key and
battery before replacing the cutting
blade. Always switch off the motor by
releasing the switch lever before
adjusting the cutting height.
WARNING
Do not rely on the
mower's insulation
against electric shock. To
reduce the risk of electro-
cution, never operate this
mower in the vicinity of
any wires or cables
(power, etc.) which may
be carrying electric
current.
Do not overload your mower during
operation to a point where the motor
slows down. If motor speed begins to
slow, select a higher cutting height or
reduce the feed rate.
Switching the mower on and off
frequently within a short period may
cause the motor to overheat.
If the motor is thermally overloaded
during operation, it is designed to cut out
automatically and must cool down
before it is restarted. Causes of
overload:
Mowing overlong grass or cutting
–
height set too low.
Feed rate too high from walking too
–
fast.
Dirty cooling air inlets (intake slots).
–
Do not mow at temperatures below
41 °F (5 °C).
Do not mow wet grass.
The drive motor is not
waterproof. Never work
with the lawn mower in
the rain or in wet or very
damp locations.
Do not leave the mower outdoors in the
rain.
MAINTENANCE, REPAIR AND
STORING
If you make a warranty claim for a
component which has not been serviced
or maintained properly or if
nonapproved replacement parts were
used, STIHL may deny coverage.
RMA 410 C