GE GBC12IAX Manual Del Propietario E Instalación página 13

HANG THE FREEZER DOOR
8
Using a thin-blade screwdriver, pry the center
A
hinge plug from the cabinet. Be careful not to
scratch the surface.
Install the center hinge plug on the right side
B
of the cabinet where the hinge bracket was
removed.
Center Hinge Plug
Make sure the washer(s) are in place
C
on the bottom hinge pin. Place the freezer door
on the bottom hinge.
Close the door and tape it in place with
D
masking tape.
INSTALL CENTER HINGE
9
Insert the pin on the bottom of the center hinge
A
into the freezer door on the left side with the
back of the bracket against the cabinet. The
hinge bracket will have to be inverted for this
installation. Using screws previously removed,
attach the hinge to the cabinet.
B Remove the tape holding the door shut.
CAUTION:
When assembled correctly,
the hinge is tight against the cabinet.
ATTENTION: Screws must be properly tightened.
Turn the screws until snug. Then tighten the screws
a minimum of 1/2 turn using both hands.
Installation Instructions
Screws
TRANSFER FRESH FOOD DOOR
10
HANDLE
A
Using a thin-blade screwdriver, carefully
remove the square button plugs from the
handle. NOTE: Be careful not to scratch
the stainless steel or plastic surfaces.
Remove the round button plugs on the other
B
side of the door. NOTE: Be careful not to scratch
the stainless steel surface.
Using a Phillips screwdriver, remove the screws
C
from the handle.
Insert the round button plugs into holes
D
on the hinge side of the door. NOTE: Be careful
not to scratch stainless steel.
E
Place the door handle over the holes
on the handle side of the door. Attach
using the screws removed earlier.
F
Insert the square button plugs over the handle
screws. NOTE: Be careful not to scratch
stainless steel or plastic surfaces.
Square
Button
Plugs
Phillips
Screws
13
Round
Button
Plugs