Brush Cleaning; Tank And Vacuum Grid Cleaning - Advance Micromatic M17E Instrucciones De Uso

ENGLISH

BRUSH CLEANING

NOTE
It is advisable to wear protective gloves when cleaning the brush because there may be sharp debris.
1. Remove the brush, as shown in the Use chapter.
2. Clean and wash the brush with water and detergent.
3. Check the brush bristles for integrity and wear; if necessary, replace the brush.

TANK AND VACUUM GRID CLEANING

1. Drive the machine to the appointed disposal area.
2. Make sure that the power supply cable (21) is disconnected from the electrical mains.
3. Open the cover (6), then clean and wash the cover, the tanks (26 and 27) and the vacuum grid (36) with clean water.
Drain the water from the tanks with the drain hose (16) and the valve (18).
4. If necessary, release the retainers (B, Fig. 7), open the vacuum grid (A), remove the fl oat (C), carefully clean and reinstall
them.
5. Check the recovery tank cover sealing gasket (D) for integrity.
NOTE
The gasket (D) creates vacuum in the tank that is necessary for the vacuuming of recovery water.
If necessary, replace the gasket (D) after removing it from its housing (E).
When reassembling the new gasket, install the joint (F) in the central area as shown in the fi gure.
6. Check the bearing surface (D) of the gasket (G) for integrity and sealing capabilities.
7. Check the compensation hole (28) for clogging.
NOTE
The hole (28) compensates the air in the cover air gap, thus allowing the creation of vacuum in the recovery tank.
8. Close the recovery tank cover (6).
E
18
INSTRUCTIONS FOR USE
D
909 5855 000(3)2008-11
F
G
C
Figure 7
Micromatic™ M17E
B
A
B
S310231B